Super MegaVerter® Series

High Reliability/COTS AC/DC Converters

	Industry Standard 4.59" x 2.4" x 0.5" Package
	High Power Density up to 90.78W/ Inch³
	High Typical Efficiency of 88.5% at 230VAC
	Low Output Noise

	Thermal Protection
	Over Voltage Protection
	Current Limit/Short Circuit Protection
	Adjustable Output Voltage 60-120% of Vo, Set
	Remote Sense
	Power On Signal (ENA) Open Collector (10mA sink current). Low (ON) When Output is Present

SMV500 series

Absolute Max Ratings (Min to Max) Specifications

Input Voltage (AC(L)) to AC(N)	300 VAC with No Damage
Power Factorr correction	0.95 min HL-LL and Full Load
Storage Temperature	-55 to +125°C
Storage Humidity	10 to 95%
Operating Temperature	-40 to 100°C; Temp measurement shall be taken from the baseplate (See spec sheet for details)
Operating Humidity	20 to 95%

Input Specifications

Isolation Specifications

Input-Output	3000VAC, 60S
Input-Case	2500VAC, 60S
Output-Case	1500VDC, 60S
Input-Output Capacitance	2000pF
Isolation Resistance	100MΩ @ Tb=25°C & 70%RH Output to Baseplate - 500VDC

Structural Dynamics

Vibration	(Note 4)
Shock	196.1mS²

Output Specifications

Output Voltage & Current	See Selection Chart Above
Output Set Point	See Selection Chart Above
Output Voltage Adjustment Range	16.8-33.6VDC @ FL
Load Regulation	56mV typ. NL-FL
Line Regulation	56mV typ. HL-LL
Ripple/Noise p-p max. (Note 1)	280mV
Dynamic Response: Peak Deviation Settling Time	3%Vo, set (Note 6) 300uS
Current Limit (Note 2)	105-140% of Rated Load
Over Voltage Protection	125-145% Vo, set, Io=0.5A, clamp
Over Temperature Protection Shutdown Auto Recovery	110°C typ. 90°C min.
Efficiency	86.5% @ 110 Vin, FL; 885.5 @ 230Vin, FL; See Spec Sheet for Efficiency Curve; Tb=25°C

Physical Specifications

Notes

1. Bandwidth 5Hz to 20 MHz and with filter 4.7nF MLCC series 50Ω min. Output Capacitor: 470uF*2, Tc≥-20°C, 470uF*4, Tc≤-20°C.

2. Current Limit inception point Vo=90% of Vo, Set @ Tb=25°C, auto recovery.

3. Turn on @ 265Vin, External components are needed for operation Refer to Fig. 3 for application circuit.

4. Sine Wave, 10-55Hz (Sweep for 1 min.), Amplitude 0.825mm Constant (Max. 0.5g) X, Y, Z 1 Hour each, at No Operation.

5. Temperature measurement shall be taken from the baseplate (Tb). See Spec Sheet for location and definition.

6. 0.1A/ µS; with cap 940µF/35V, Tb=25°C, Vin=200VAC.

All specifications are typical at nominal input, full load, and 25°C unless otherwise noted